Español
English
Français
Nederlands
Italiano
Deutsch
[./micro1ukpag.html]
[./micro1pag.html]
[./19alhomeukpag.html]
[./infosukpag.html]
[mailto:mid_belgium@hotmail.com]
[./micro1ukpag.html]
[./micro2ukpag.html]
Next Page
Previous Page
Message
Infos
Home Page
MI-1 - MICRO SET Micro Set is a very versatile decal setting solution that does several things to the Microscale Decals to improve application. Micro Set should be applied to the surface of the model where you will be sliding off the decal. Micro Set prepares the surface with special wetting agents that cuts the oils in new paint and converts the adhesive on the back of the decal to a stronger and more lasting one. And finally, Micro Set slightly softens the decals film to make it more flexible so that it can conform better to the model's surface. Better adhesion by the decal to the model prevents tiny air bells from occurring and results in an invisible carrier film or the so called 'painted on look'. To apply Micro Set, use a soft flat artist's brush and apply Micro Set where you are going to apply the decal. Then slide off the decal. Using a small pointed tip synthetic bristle carefully position the decal. Blot the decal carefully with tissue or paper towelling so as not to move it and allow to dry overnight. It is ready for a protective coat of Micro Coat Flat, Satin or Gloss.
MI-1 MICRO SET MI-2 MICRO SOL MI-3 MICRO COAT FLAT MI-4 MICRO COAT GLOSS MI-5 MICRO COAT SATIN MI-6 MICRO WELD MI-7 MICRO MASK MI-8 MICRO METAL FOIL ADHESIVE MI-9 MICRO KRISTAL KLEAR MI-10 MICRO LIQUITAPE MI-12 MICRO LIQUID DECAL FILM
MI-2 - MICRO SOL Micro Sol setting solution is for the most difficult irregular surfaces you find on models. It completely softens the Microscale Decal allowing it to drape down onto the surface of the model conforming perfectly and without distortion. You can get the most amazing results in seemingly impossible places, because Micro Sol actually makes the decal part of the paint. For that reason you should coat Micro Sol on for only a few seconds and then leave it alone, it does the work. Do not touch until dry as the decal is very soft at this stage and could be easily damaged. For the best results, first apply Micro Set to prepare the surface and enhance the adhesive. Make sure the surface is free of particles that could get under and blemish the decal. Then when dry enough so that the decal will not move easily apply Micro Sol with a small flat brush. Apply with as few strokes as possible so as not to disturb the decal. Then just allow to dry. One application works in most cases, but if necessary allow to dry completely and reapply until the desired affect is achieved. Just by following these simple instructions, you should have a perfect professional looking job.
[./micro3ukpag.html]
[Web Creator] [LMSOFT]